UA   RU  EN

TIPS FOR APPLYING NON-FLIZED PHOTO WALLPAPERS and VINYL WALLPAPERS ON A NON-FLIZED BASE

CHECK THE QUALITY OF THE WALLPAPER BEFORE APPLYING!

IF THE WALLPAPER IS ALREADY PUT UP, THEN CLAIMS FOR THE QUALITY OF THE WALLPAPER WILL NOT BE ACCEPTED!

1. The substrate must be dry, level, clean and chemically neutral. .

2. Walls should be dim and plain.

3. At high humidity, vinyl wallpaper is not allowed. .

4. If the wall surface is gypsum plaster, it must be sanded and then primed.

5. Surfaces that are too smooth will need to be coated with a primer initially. R-35.

6. Use a plumb bob! Walls are rarely perfectly straight. .

7. To draw a reference line, measure from the corner a distance 1/2 inch less than the width of the wallpaper. .

8. If you glue the first sheet straight, the rest will also stick straight if you carefully join the edges. .

9. By purchasing non-woven photo wallpaper , before cutting, be sure to check the sequence of gluing the canvases in accordance with the ordered image.

10. For markings you need to use a pencil, not a felt-tip pen

11. Prepare glue according to instructions.

12. The next step is to apply the glue prepared in advance to the wall. .

13. After applying the glue, take the first canvas and, adjusting it in height, begin gluing it along the marked line on the wall.

14. Immediately begin smoothing the wallpaper, expelling all the air from under it. .

15. The best quality of the joint will be obtained when gluing the wallpaper "overlapping". .

a) - overlapping sticker;
c) ​​- separation of cloth;

16. Hold the strip to the wall. .

17. Glue is applied to the wall and the canvas begins to stick. .

18. Under no circumstances should a clear joint be achieved by stretching the wallpaper; even if this can be done, the joint will separate after the wallpaper dries. .

19. Use high-quality glue with a thick consistency, do not dilute it.

20. Switches: Before covering the walls, remove, if possible, all sockets and switches. .

21. When dry, wallpaper does not tolerate temperature changes (drafts) and humidity..

22. After drying, the wallpaper can be coated with water-based acrylic varnish. .

Panel varnish ИР-11
Resistant to water and household chemicals
Environmentally friendly aqueous solution of acrylic copolymer dispersion FINNDISP® No VOC.

Note: guarantee for the quality of gluing is given only when wallpaper is glued by our specialists.




Photo wallpaper.